ADJUSTMENT
B546 40 SM
3.2.2 JOGGER FENCE POSITION
After replacing the finisher board or if a paper alignment fault occurs, do this
adjustment.
Doing this adjustment once will affect all paper sizes.
1. Remove the upper rear cover.
2. Turn on dip switch 3-1 on the finisher board.
3. Press the following switch on the finisher board.
Using A4: Switch 1 (SW1)
Using 81/2" x 11": Switch 2 (SW2)
• After pressing the switch, the upper exit unit will open and the jogger fences
will move to the A4 or 81/2" x 11" position.
4. Place 10 sheets of A4/81/2" x 11" paper between the jogger fences and push
them until they touch the shutters.
5. Adjust the jogger fence position by pressing switch 1 or 2.
• Switch 1: Move to the front (0.35 mm/press)
• Switch 2: Move to the rear (0.35 mm/press)
6. Press switches 1 and 2 simultaneously to store the adjustment data.
• After pressing the switches, the upper exit unit will close.
7. Turn off dip switch 3-1, then turn off the copier main switch.
SW1
SW2
Dip Switch 3
LED 2
LED 1
B546R550.WMF
Rear
Jogger Fence
Jogger Fence
Front
SW2
SW1
Shutter
B546R553.WMF
1
Dip Switch 3
23 56784
ON
B546R552.WMF
To Next Page
Loading...
