BIT SWITCHES
B779 48 SM
3.2.2 I-Fax Switches
I-fax Switch 00 SP No. 1-102-001
FUNCTION COMMENTS No
Original Width of TX
Attachment File
This setting sets the maximum size of the original
that the destination can receive. (Bits 3~7 are
reserved for future use or not used.)
0 A4
1 B4
2 A3
3-6 Reserved
7 Not used
0: Off (not selected), 1: On (selected)
If more than one of these three bits is set to “1”, the
larger size has priority. For example, if both Bit 2
and Bit 1 are set to “1” then the maximum size is
“A3” (Bit 2).
When mail is sent, there is no negotiation with the
receiving machine at the destination, so the sending
machine cannot make a selection for the receiving
capabilities (original width setting) of the receiving
machine. The original width selected with this switch
is used as the RX machine’s original width setting,
and the original is reduced to this size before
sending. The default is A4.
If the width selected with this switch is higher than
the receiving machine can accept, the machine
detects this and this causes an error.
To Next Page
Loading...
