STAMP
SM 23 B714
Auto Reverse
Document
Feeder B714
4.6 STAMP
NOTE: This function is only for fax mode.
The stamp [A] is located between the transport roller [B] and the exit roller [C].
When the original reaches the stamp, the transport motor stops and the stamp
solenoid turns on if the page is sent successfully (immediate transmission) or
stored successfully (memory transmission). After stamping, the ARDF feed motor
re-starts to feed out the document.
NOTE: The position of the stamp can be adjusted with the Stamp Position
Adjustment SP mode.
B597D201.WMF
[A]
[B]
[C]
To Next Page
Loading...
