EasyManua.ls Logo

Ricoh B264 - Ip-Fax Troubleshooting; IP-Fax Transmission

Ricoh B264
918 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
IP-FAX TROUBLESHOOTING
B779 24 SM
2.3 IP-FAX TROUBLESHOOTING
IP-Fax Transmission
Cannot send by IP Address/Host Name
Check Point Action
1 LAN cable connected? Check the LAN cable connection.
2 Specified IP address/host name correct? Check the IP address/host name.
3 Firewall/NAT is installed? Cannot breach the firewall. Send by using
another method (Fax, Internet Fax)
4 Transmission sent manually? Manual sending not supported.
5 IP address of local machine registered? Register the IP address.
6 Remote terminal port number setting other
than 1720?
Send by specifying the port number.
7 Specified port number correct? Confirm the port number of the remote fax.
8 DNS server registered when host name
specified?
Contact the network administrator.
9 Remote fax a T.38 terminal? Check whether the remote fax is a T38
terminal.
10 Remote fax switched off or busy? Check that the remote fax is switched on.
Request the network administrator to
increase the bandwidth.
Raise the delay level.
IPFAX SW 01 Bit 0 to 3
11 Network bandwidth too narrow?
IP-Fax bandwidth is the same as the DCS
speed. Set IP-Fax SW00 Bit 6 to 1.
12 Remote fax cancelled transmission? Check whether the remote fax cancelled
the transmission.

Table of Contents

Related product manuals