SCANNING
B264/B265 6-16 SM
Original Size Length Sensor
Width
Sensor
A4/A3 version LT/DLT version L3 L2 L1 W2 W1
SP4-301
display
A3 11” x 17” O O O O O 00011111
B4 10” x 14” O O O X O 00011101
F4 8.5” x 14” (8” x 13”) O O O X X 00011100
A4-L 8.5” x 11” X O O X X 00001100
B5-L X X O X X 00000100
A4-S 11” x 8.5” X X X O O 00000011
B5-S X X X X O 00000001
A5-L, A5-S 5.5” x 8.5”, 8.5” x 5.5” X X X X X 00000000
NOTE: L: Lengthwise, S: Sideways, O: Paper present X: Low
For other combinations, "CANNOT DETECT ORIG. SIZE" will be indicated on the
operation panel display.
The above table shows the outputs of the sensors for each original size. This
original size detection method eliminates the necessity for a pre-scan and
increases the machine's productivity.
However, if the by-pass tray is used, note that the machine assumes that the copy
paper is lengthwise (L). For example, if A4 sideways paper is placed on the by-
pass tray, the machine assumes it is A3 paper and scans a full A3 area,
disregarding the original size sensors.
W1
W2
L3L2L1
B195D909.WMF
To Next Page
Loading...
