Ricoh B264 - Page 718

ADJUSTMENT
B546 44 SM
Dip switch 1 -6, -7, -8 setting
-6 -7 -8
Adjustment
(0.25 mm/ step)
OFF ON ON +3
OFF ON OFF +2
OFF OFF ON +1
OFF OFF OFF 0
ON OFF ON -1
ON ON OFF -2
ON ON ON -3
ON OFF OFF Do not use
8. Measure the distance (L) between the stapling position and the folder position.
9. Adjust the stapling position with dip switches 1 -6, -7, -8.
Inputting a lower value than the current setting moves the stapling position
towards the leading edge. Adjusting by 1 step moves the stapling position 0.25
mm.
Example 1:
To move the stapling position 1 mm towards the leading edge.
If dip switch 1 is currently set to +2, set the dip switch to reflect -2 (this moves
the stapling position 4 steps towards the leading edge).
Example 2:
To move the stapling position 0.75 mm away from the leading edge.
If dip switch 1 is currently set to -1, set the dip switch to reflect +2 (this move,s
the stapling position 3 steps away from the leading edge).
10. Turn off dip switched 1-1 and -2, then turn off the copier main switch.
Mark
Example 1: L= 1 mm
Adjust towards the leading edge
L
Mark
Example 2: L= 0.75 mm
Adjust away from the leading edge
L
Stapling Position
Folding Position
Folding Position
Stapling Position
B546R559.WMF