BIT SWITCHES
B779 46 SM
System Switch 1D SP No. 1-101-030
No FUNCTION COMMENTS
0
RTI/CSI/CPS code display
0: Enable
1: Disable
0: RTI, CSI, CPS codes are displayed on the top line
of the LCD panel during communication.
1: Codes are switched off (no display)
1 Not used Do not change this setting.
2
Destination telephone number
display limitation
0: OFF, 1: ON
When "1" is selected, the destination telephone
number display is limited and redial is disabled.
3-7 Not used Do not change these settings.
System Switch 1E SP No. 1-101-031
No FUNCTION COMMENTS
0
Communication after the
Journal data storage area has
become full
0: Impossible
1: Possible
0: When this switch is on and the journal history
becomes full, the next report prints. If the journal
history is not deleted, the next transmission cannot
be received. This prevents overwriting
communication records before the machine can
print them.
1: If the buffer memory of the communication
records for the Journal is full, fax communications
are still possible. But the machine will overwrite the
oldest communication records.
Note: This setting is effective only when Automatic
Journal printout is enabled but the machine cannot
print the report (e.g., no paper).
1
Action when the SAF memory
has become full during
scanning
0: The current page is erased.
1: The entire file is erased.
0: If the SAF memory becomes full during scanning,
the successfully scanned pages are transmitted.
1: If the SAF memory becomes full during scanning,
the file is erased and no pages are transmitted.
This bit switch is ignored for parallel memory
transmission.
2
RTI/CSI display priority
0: RTI 1: CSI
This bit determines which identifier, RTI or CSI, is
displayed on the LCD while the machine is
communicating in G3 non-standard mode.
3
File No. printing
0: Enabled
1: Disabled
1: File numbers are not printed on any reports.
4
Action when authorized
reception is enabled but
authorized RTIs/CSIs are not
yet programmed
0: All fax reception is disabled
1: Faxes can be received if the
sender has an RTI or CSI
If authorized reception is enabled but the user has
stored no acceptable sender RTIs or CSIs, the
machine will not be able to receive any fax
messages.
If the customer wishes to receive messages from
any sender that includes an RTI or CSI, and to block
messages from senders that do not include an RTI
or CSI, change this bit to “1”, then enable
Authorized Reception.
Otherwise, keep this bit at “0 (default setting)”.
5-7 Not used Do not change the settings
To Next Page
Loading...
