BIT SWITCHES
B779 58 SM
Printer Switch 0E SP No. 1-103-015
No FUNCTION COMMENTS
0
Paper size selection priority
0: Width
1: Length
0: A paper size that has the same width as the
received data is selected first.
1: A paper size which has enough length to print all
the received lines without reduction is selected first.
1
Paper size selected for
printing A4 width fax data
0: 8.5" x 11" size
1: A4 size
This switch determines which paper size is selected
for printing A4 width fax data, when the machine has
both A4 and 8.5" x 11" size paper.
2
Page separation
0: Enabled
1: Disabled
1: If all paper sizes in the machine require page
separation to print a received fax message, the
machine does not print the message (Substitute
Reception is used).
After a larger size of paper is set in a cassette, the
machine automatically prints the fax message.
3
to
4
Printing the sample image on
reports
Bit 4 Bit 3 Setting
0 0 The upper half
only
0 1 50% reduction
in sub-scan only
1 0 Same size
1 1 Not used
“Same size” means the sample image is printed at
100%, even if page separation occurs.
User Parameter Switch 19 (13H) bit 4 must be set to
“0” to enable this switch.
Refer to Detailed Section Descriptions for more on
this feature.
5-6 Not used Do not change the settings.
7
Equalizing the reduction ratio
among separated pages
(Page Separation)
0: Enabled
1: Disabled
0: When page separation has taken place, all the
pages are reduced with the same reduction ratio.
1: Only the last page is reduced to fit the selected
paper size when page separation has taken place.
Other pages are printed without reduction.
Printer Switch 0F SP No. 1-103-016
No FUNCTION COMMENTS
0
to
1
Smoothing feature
Bit 1 Bit 0 Setting
0 0 Disabled
0 1 Disabled
1 0 Enabled
1 1 Not used
(0, 0) (0, 1): Disable smoothing if the machine
receives halftone images from other manufacturers
fax machines frequently.
2
Duplex printing
0: Disabled
1: Enabled
1: The machine always prints received fax
messages in duplex printing mode:
3
Binding direction for Duplex
printing
0: Left binding
1: Top binding
0: Sets the binding for the left edge of the stack.
1: Sets the binding for the top of the stack.
4-7 Not used Do not change the settings.
To Next Page
Loading...
