Ricoh B264 - Page 840

NCU PARAMETERS
B779 88 SM
Address Function Unit Remarks
68052F Busy tone OFF time: range 3
680530 Busy tone ON time: range 4
680531 Busy tone OFF time: range 4
680532
Busy tone continuous tone detection
time
20 ms
680533
Busy tone signal state time tolerance for all ranges, and number of cycles
required for detection (a setting of 4 cycles means that ON-OFF-ON or OFF-ON-
OFF must be detected twice).
Tolerance (±)
Bit 1 0
0 0 75% Bits 2 and 3 must always
0 1 50% be kept at 0.
1 0 25%
1 1 12.5%
Bits 7, 6, 5, 4 - number of cycles required for cadence detection
680534
International dial tone frequency
upper limit (high byte)
680535
International dial tone frequency
upper limit (low byte)
Hz (BCD)
If both addresses contain
FF(H), tone detection is
disabled.
680536
International dial tone frequency
lower limit (high byte)
680537
International dial tone frequency
lower limit (low byte)
Hz (BCD)
If both addresses contain
FF(H), tone detection is
disabled.
680538 International dial tone detection time
680539
International dial tone reset time
(LOW)
68053A
International dial tone reset time
(HIGH)
68053B
International dial tone continuous
tone time
68053C
International dial tone permissible
drop time
If 680538 contains FF,
the machine pauses for
the pause time (68053D /
68053E).
Belgium: See Note 2.
68053D International dial wait interval (LOW)
68053E International dial wait interval (HIGH)
20 ms
68053F
Country dial tone upper frequency
limit (HIGH)
680540
Country dial tone upper frequency
limit (LOW)
If both addresses contain
FF(H), tone detection is
disabled.
680541
Country dial tone lower frequency
limit (HIGH)
680542
Country dial tone lower frequency
limit (LOW)
Hz (BCD)
If both addresses contain
FF(H), tone detection is
disabled.
680543 Country dial tone detection time
680544 Country dial tone reset time (LOW)
680545 Country dial tone reset time (HIGH)
If 680543 contains FF,
the machine pauses for
the pause time (680548 /
680549).
680546
Country dial tone continuous tone
time
20 ms