5. Translucent paper (including OHP)
NOTE
The above types of paper may be used as an
original in the SADF mode.
6. Damp paper
7. Bound originals
8. Paper that is thicker or thinner than specified for this machine
Originals that have holes as shown cannot be used in
the ADF mode.
A: No holes are allowed on the leading
edge. (To prevent multifeeding.)
B: No holes are allowed in these areas.
(The recycle arm may be caught in the
holes.)
C: Holes larger than 6 mm in diameter are
not allowed on the trailing edge.
D: Holes larger than 10 mm in diameter are
not allowed in the center. (To prevent sen-
sor’s misdetection.) This type of paper can-
not be used in the SADF mode either.
Paper replenishment
When the 2nd or 3rd paper tray runs out of paper and the indication Add paper lights in red, this
means there are still about 50 sheets of paper left in the tray.
Fusing oil
The pick-off pawls of the fusing unit sometimes make slight oil marks on the leading edge of copies .
Copy image area
1. The blank range is provided as shown to prevent
original shadows on copies.
2. Damp copy paper will have an 8 mm blank margin
(or less) at the trailing edge of the front side, and if
duplex copying, the back side will have a blank
margin of 10 mm (or less) at the trailing edge.
[Leading edge]
10 mm
50 mm
10 mm
100 mm
100 mm
A
B
C
D
B
[Leading edge]
Total of left and right
should be 7 mm or
less.
1 July 1994 User Guidance Items
1-19
To Next Page
Loading...
