FUSING
SM 3-47 G065
Replacement
and
Adjustment
7. Hot roller [A]
CAUTION: The hot roller is easily damaged. Always handle it carefully.
8. C-rings x 2 [B] (both ends)
9. Drive gear [C]
10. Bushings x 2 [D] (both ends)
11. Pressure roller [E]
12. Fusing knob [F] (! x 1)
13. Bushings x 2 [G] (both ends)
NOTE: 1) Before installing the new hot roller, peel off 3 cm (1 inch) from both
ends of the protective sheet on the new roller.
2) Never touch the surface of the rollers.
3) Work carefully to avoid damaging the surface of the hot roller.
4) The standard pressure roller spring position is the upper position.
5) When reinstalling the hot roller assembly and pressure roller
assembly, make sure that the flange position of the bushings is as
shown.
G065R903.WMF
[A]
[B]
[C]
[D]
[E]
[F]
[G]
[B]
To Next Page
Loading...
