PRINTER ENGINE SERVICE MODE
SM 5-21 G065
Service
Tables
4. HDD (SP4000-00)
SP4 Mode Number Function and [Setting]
4911 01
Format HDD
Formats the hard disk. After execution, you must
cycle the machine off and on with the power
switch.
5. Mode (SP5000-00)
SP5 Mode Number Function and [Setting]
5024* 01
mm/inch Display
Selects the unit of measurement.
After selection, turn the main power switch off
and on.
0: mm, 1: inch
5104* 01
A3/DLT Double Count
Specifies whether the counter is doubled for
A3/DLT.
0: No, 1: Yes
If 1 is selected, the total counter and the current
user code counter count up twice when A3 or
DLT paper is used.
5129 01
F Paper Selection
Three selections are available for F-size paper.
[0 ~2 / 0 / 1 step]
0: Foolscap 8" x 13" Lengthways (SEF)
1: Foolscap 8
1/2
" x 13" Lengthways (SEF)
2: Folio 8
1/4
" x 13" Lengthways (SEF)
5131* 01
Paper Size Type Selection
Selects the paper size type for printing..
[0~2 / DIP SW setting / 1 step]
0: Japan
1: North America
2: Europe
After changing the setting, turn the copier off and
on. If the paper size of the archive files stored on
the HDD is different, abnormal prints could
result.
5501 03
PCU Count
Sets the timing of the display warning for
replacing the PCU. When printing reaches this
total, the replace PCU warning is issued.
[40 ~ 150 / 150 / 10K step]
Using the default setting, when the number of
prints reaches 150,000 (150 x 1,000) the
warning is issued with the PM Counter Display
(SP7803).
5801*
Memory Clear
Resets all correction data for process control
and all software counters, and returns all modes
and adjustments to their default values. (☛
5.3.5)
Use this SP only after replacing the NVRAM, or
after the printer has malfunctioned due to a
damaged NVRAM.
To Next Page
Loading...
