Ricoh G065 - Page 180

PRINTER ENGINE SERVICE MODE
G065 5-22 SM
SP5 Mode Number Function and [Setting]
5802*
Printer Free Run
Performs a free run. The printer prints the
number of blank prints requested for testing.
[0 ~ 1 /0 / 1 step]
0: Free run mode off.
1: Free run mode on.
5803*
Input Check
Displays the signals received from sensors and
switches. (☛ 5.3.3)
5804*
Output Check
Turns on the electrical components individually
for test purposes. (☛ 5.3.4)
Option Connection Check
02
Bank
03
LCT
5807*
04
Finisher
Checks the connectors to the optional peripheral
devices. Execution will return either a “1” or “0”:
0: Device not connected correctly.
1: Device connected correctly.
5810
SC Clear
When an SC error is issued for the fusing
system (SC54x), the printer cannot be released
from the SC status by cycling the machine off
and on. The service technician must execute
SP5810 to restore the printer to normal
operation.
5811* 01
Machine Serial Number
Used to input the machine serial number (limit:
11 digits). This is normally done at the factory.
DFU
5812 02
Service Fax Number
Enter the telephone number of the service
representative. The fax number is printed
automatically when a service call error occurs.
The number entry is limited to 20 digits,
including hyphens.
25
Network Software Switch
Sets the information for the software used on the
network.
[00000000h ~ FFFFFFFh / 00000000h / 1 hex]
27
Network SYSLOG Server
Address Setting
Sets the address for the Syslog Server.
[00000000h ~ FFFFFFFFh / 7F000001h / 1 step]
7F000001h (127.0.0.1)
28
Network Time Server
Address Setting
Sets the time server address.
[00000000h / 00000000h / 1 step]
30
Network Direct Port Number
Setting
Sets the port number for TCP direct printing.
[1024 ~ 65535 / 9100 / 1 step]
32
Network IPX Address Setting
(NetWare)
Sets the IPX address used by NetWare on the
network. (Allowed entry: 12 numerics)
34
Network Software Switch
Setting (NetWare)
Sets the NetWare software information used by
the network.
[0000h ~ FFFFh / 0003h / 1 hex]
36
Network AppleTalk Module
Setting
Sets the mode for the operation of AppleTalk on
the network with multiple protocols.
2: EtherTalk Phase2
37
Network NetNo Setting
(AppleTalk)
Sets NetNo information using AppleTalk on a
network using multiple protocols. (Range: 12
characters)
5828*
38
Network Object Name
Setting (AppleTalk)
Sets the object AppleTalk object name for a
network using multiple protocols.
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA