IMAGE FUSING AND PAPER EXIT
G065 6-52 SM
6.13.2 FUSING DRIVE
The fusing/paper exit motor [A]
drives the fusing unit through the
clutch [B] and the gears [C], and
also drives the paper exit rollers [D]
through a gear and a timing belt [E].
6.13.3 FUSING ENTRANCE GUIDE SHIFT MECHANISM
The entrance guide [A] has two
holes on each side to adjust for
paper thickness to prevent creasing.
Normally, the left screw hole [C] on
each side is used.
For thin paper, use screw holes [B]
to move the entrance guide to the
left. This setting allows more direct
access to the gap between the hot
and pressure rollers, and prevents
thin paper from buckling against the
hot roller which can cause blurring
at the leading edge of the print.
G065D903.WMF
G065D610.WMF
[A]
[B]
[C]
[D]
[E]
[C]
[B]
[A]
To Next Page
Loading...
