DEVELOPMENT
G065 3-26 SM
3.1.5 TD SENSOR
1. Remove the development unit (☛ 3.11.1)
2. Empty all developer from the development unit (☛ 3.11.4)
3. TD sensor [A] (! x 1)
NOTE: The TD sensor is attached to the casing with double-sided tape. Pry it
off with the flat head of a screwdriver. Use fresh double-sided tape to
re-attach the sensor.
4. Pour new developer into the development unit and perform the TD sensor initial
setting using SP2801.
NOTE: When performing the TD sensor initial setting, cover the toner entrance
hole with a piece of paper (☛ 3.11.4).
G065R975.WMF
[A]
To Next Page
Loading...
