PRINTER ENGINE SERVICE MODE
SM 5-35 G065
Service
Tables
5.1.4 OUTPUT CHECK
NOTE: Motors keep turning in this mode regardless of upper or lower limit sensor
signals. To prevent mechanical or electrical damage, do not keep an
electrical component on for a long time.
Enter the SP mode and select SP5804.
1. Press !" together (5s), release, then press #(Enter).
System Ver.1.00
1. Service
2. Press ".
System Ver. 1.00
2. Engine
3. Press #(Enter).
<Engine>
1. Feed
4. Press " to display “5. Mode”.
<Engine>
5. Mode
5. Press #(Enter).
SP5024
mm/inch Display
6. Press ! repeatedly to display “Output Check”.
SP5804 >>
Output Check
7. Press #(Enter).
SP5804-001
1st.PaperFeedCl.
8. Press ! or " to display the item to check.
SP5804-027
Fuser Exit Motor
9. Press #(Enter).
<Fuser Exit Motor>
10. Press #(Enter) to switch the component on, then press #(Enter) to switch it off.
Fuser Exit Motor
Fuser Exit Motor
11. Press (Escape) then repeat Steps 8 to 11 to check other items.
12. When you are finished press (Escape) until you see “2.Engine” then select
“3.End”.
To Next Page
Loading...
