PRINTER CONTROLLER SERVICE MODE
G065 5-2 SM
5.2 PRINTER CONTROLLER SERVICE MODE
5.2.1 CONTROLLER SERVICE MODE MENUS
The controller service mode menu (1.Service) is the first item on the menu.
Item What It Does
Bit Switch Adjusts the bit switch settings.
Clear Setting Initializes the settings for the “System” menu of the user mode.
Print Summary Prints a summary of all the controller settings.
Display Version Displays the current version number of the controller firmware.
5.2.2 BIT SWITCH PROGRAMMING
1. Enter the SP mode, select “1.Service”, and press #(Enter) twice.
SP1001-001
Bit Switch 1 Set
2. Press ! or " to select the bit switch setting to change.
SP1001-002
Bit Switch 2 Set
3. Press #(Enter).
Sw#2 00000000
bit0 _
4. Select the “0” or “1” for each position. The leftmost digit is 7 and the rightmost
is 0.
• Press ! or " to move the cursor to the right or left to position the it at the
digit to change.
• Press #(Enter) then press ! or " to toggle the digit between “1” and “0”.
• With the digit for entry displayed on the second line, press #(Enter). The
selected digit is entered into the position above.
• Repeat this procedure to set all the digits.
5. When you are finished, press (Escape) to return to the previous level. The
new settings for the bit switch are now stored.
To Next Page
Loading...
