PRINTER ENGINE SERVICE MODE
SM 5-29 G065
Service
Tables
5.1.2 TEST PATTERN PRINTING
Enter the SP mode and select SP2902.
1. Press !" together (5s), release, then press #(Enter).
System Ver.1.00
1. Service
2. Press "
System Ver. 1.00
2. Engine
3. Press #(Enter).
<Engine>
1. Feed
4. Press ".
<Engine>
2. Drum
5. Press #(Enter).
SP2001>>
Charge Roll Bias
6. Press " to display “Test Pattern”
SP2902
Print T Pattern
7. Press #(Enter).
00
_
8. Press !" together (5s), release, then press #(Enter).
01
_
9. Press (Escape) twice then print an SMC Report. (☛ 5.3.6)
10. Repeat this procedure to print as many test prints as needed.
NOTE: 1) After you enter a Print Test Pattern number, when you execute the SMC
Report print procedure, the test pattern prints, not the SMC Report.
2) The machine will remain in this mode until you leave the Service Mode,
or switch the printer off an on.
3) After leaving the re-entering the Service Mode, or after cycling the
machine off an on, the SMC Report feature is restored to normal
operation.
To Next Page
Loading...
