IMAGE TRANSFER AND PAPER SEPARATION
SM 6-49 G065
Detailed
Descriptions
Transfer Currents to Leading Edge and Image Areas
Transfer current can also be adjusted for the leading edge and the image area, and
for by-pass feed. The timing for starting to apply leading edge current, for the
switchover from leading edge current to image area current, and for switching off at
the trailing edge can also be changed.
The table below lists the SP modes you can use to adjust these settings.
SP2301 Transfer Current Adjustment
SP2301-01 1st Side of Paper
SP2301-02 2nd Side of Paper
Image areas
SP2301-04 By-pass Feed
SP2301-03 Leading EdgeLeading edge areas
SP2301-05 Leading Edge By-pass Feed
SP2911 Transfer Current Timing
SP2911-01 On Timing at Leading Edge
SP2911-02
Switch Timing from Leading Edge
to Image Area
Timing
SP2911-03 Off Timing at Trailing Edge
To Next Page
Loading...
