Ricoh G065 - Page 181

PRINTER ENGINE SERVICE MODE
SM 5-23 G065
Service
Tables
SP5 Mode Number Function and [Setting]
47
Network Job Analysis
Timeout Setting (Centronics)
Sets the Centronics job analysis timeout for the
network.
[0 ~ 4,200 s / 3 s / 1 sec. step]
48
Network Job Timeout Setting
(Centronics)
Sets the Centronics job timeout for the network.
[0 ~ 4,200 s / 0 s / 1 sec. step]
49
Network Noise Cancel
Setting (Centronics)
Sets the noise cancel level for the network.
[4 ~ 7 / 4 / 1 clock per step]
50
Network 1284 Compatibility
Setting (Centronics)
Switches Centronics IEEE1284 compatibility
on/off for the network.
0: Disabled, 1: Enabled
Selecting “0” disables bi-directional data
transmission.
51
Network Data Transfer
Speed Setting (Centronics)
Sets the Centronics transfer speed for the
network.
0: Slow, 1: Fast
If you select “0” there will be a 120
µ
s delay from
the STP signal to the data transfer. (With 1:
FAST there is no delay.)
52
Network ECP Setting
(Centronics)
Switches the ECP setting for Centronics off/on.
0: Disabled, 1: Enabled
With “1” selected, SP5828-50 must be enabled
for 1284 mode compatibility.
53
Network Transmission
Speed Setting
Selects the Ethernet transmission speed.
[0x00 ~ 0x03 / 0x00 / 0x01 step]
Bit 1 Bit 2 Speed
0 0 Auto Sense
0 1 10Base-T
1 0 100Base-T
11Auto
5828*
66
Start Time Job Spool Clear
When the printer is powered off, spooled print
jobs on the hard disk remain there until the next
time the printer is powered on. This setting
determines whether to print spooled jobs from
the previous printing session the next time the
printer is powered on.
[0 ~ 1 / 1 / 1 step]
0: Job clear. Clears spooled jobs on the hard
disk when the printer is switched on.
1: Print jobs. Prints spooled jobs on the hard
disk when the printer is powered on.
07
IEEE1394
08
BCR Mode
09
1394a Check for IRM
10
Unique ID Enumeration
11
Force Logout
12
Exclusive Login
5839
13
Maximum Initiator Number
for Login
IEEE 1394 settings.
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA