PRINTER ENGINE SERVICE MODE
G065 5-24 SM
SP5 Mode Number Function and [Setting]
5907* 01
Plug & Play
Sets the brand name and the production name
for Windows Plug & Play. This information is
stored in NVRAM. If the NVRAM is defective or
has been replaced, these names should be
registered again.
To set the plug and play model name, enter the
model number, and then press #(Enter).
5915 01
Mechanical Counter
Detection
Checks whether the mechanical counter inside
the inner cover is connected or not.
Display:
0: Not detected
1: Detected
2: Unknown
5930 Meter Charge
This is a total count system for the PCU, fusing
unit, etc. When this setting is set, the PCU
replace time status is not issued from the
engine. However, the internal copy count
continues to function.
5958 Feed Clutch Timing Adjusts the clutch timing to optimize the intervals
between fed sheets to reduce jams in the feed
unit. DFU
[35 ~ 57.5 / 42.5 / 2.5mm step]
5970 Debug Serial Output DFU
SMC Printouts
DFU
1
All (Data List)
2
SP (Mode Data List)
4
Provisionally
5
Diagnosis Report
5990
7
NIB Summary
Prints all of the system parameter lists for the
item selected.
To Next Page
Loading...
