• When the machine recovers from Sleep mode using the human detection sensor, the main power
indicator turns on. Even if Sleep mode is canceled, the operation screen is not displayed until you
touch the touch panel.
• The energy saving functions are disabled when an error occurs or while an operation is in
progress.
• When the machine recovers from Sleep mode using the human detection sensor, the main power
indicator turns on. Even if Sleep mode is canceled, the operation screen is not displayed until you
touch the touch panel.
• The energy saving functions will not operate in the following cases:
• When fixed warm-up is in progress
• When operations are suspended during printing
• When a warning message appears (The machine enters Fusing Unit Off mode unless the
cover is open.)
• When paper is jammed (The machine enters Fusing Unit Off mode except when the cover is
open.)
• When the Data In indicator is lit or flashing (The machine enters Fusing Unit Off mode except
when the Data In indicator is lit or flashing due to receiving faxes or storing documents.)
• The machine does not enter Sleep mode in the following cases:
• During communication with external equipment
• When the hard disk is active
• When the service call message appears
• When the ADF, machine's cover, or ADF cover are opened
• When the "Add Toner" message appears
• When toner is being replenished
• When one of the following screens is displayed:
• System Settings
• Counter
• Inquiry
• Address Book
• Tray/Paper Settings
• When data is being processed
• If a file is waiting to be transmitted within the next minute using the "Send Later" facsimile function
• When a recipient is being registered in the address list or group dial list
• When the sample print, locked print, hold print, or stored print screen is displayed
2. Getting Started
16
To Next Page
Loading...
