Ricoh Pro 8310 Troubleshooting

1.SC Codes
398
 Replace the sensor harness.
SC751-73
Error Name
Perfect Binder: TE Press Lever HP Sensor Lag Error
Pattern
D
Error Condition
When the trailing edge press lever was released, the TE press lever HP sensor did not go OFF, even
though the TE press lever motor operated long enough to move the lever through and arc of 20
degrees.
Major Cause
 TE press lever sensor defective
 TE press lever motor defective
Solution
 Reconnect the connector.
 Replace the TE press lever motor.
 Replace the TE press lever HP sensor.
 Replace the master control board.
 Replace the motor harness.
 Replace the sensor harness.
SC751-74
Error Name
Perfect Binder: Jog Fence Front HP Sensor Late Error
Pattern
D
Error Condition
The front jog fence HP sensor did not go ON, even though the jog fence motor operated long enough
for 60 mm of feed.
Major Cause
 Jog fence front HP sensor defective
 Jog fence front motor defective

Ricoh Pro 8310 Specifications

General

Brand	Ricoh
Model	Pro 8310
Category	All in One Printer
Language	English