Ricoh Pro 8310 - Delivered Sheets Are Not Stacked Properly; Finisher SR5090; Booklet Finisher SR5100; If There Are too Many Stacked Sheets

4.Troubleshooting for Peripheral Units
786
Finisher SR5090/ Booklet Finisher SR5100
Delivered Sheets Are Not Stacked Properly
Solution
Depending on the cause of the problem, do one of the following:
 Coated paper is used.
 If one sheet pushes out another sheet, specify the convex curl correction (face curl) on the
decurl unit.
 To improve stacking, install the output jogger unit.
 There is airflow in the room.
Minimize the airflow. For instance, turn the air conditioner off.
If Printed Sheets are Curled
If the decurl unit is used, do the following:
1. On the Adjustment Settings for Skilled Operators menu, select Machine: Paper Feed/ Output >
Adjust Paper Curl > Select the amount of curl correction. (SP 1-906-001 to 012: De-curler Setting
Tray <number> :Paper Path Selection)
 To correct curls facing up, specify "Adjust Concave Curl".
 To correct curls facing down, specify "Adjust Convex Curl".
2. Select "Strong" or "Weak" depending on the amount of curl correction required.
If the decurl unit is not used, remove the paper stack and turn it upside down.
If There Are Too Many Stacked Sheets
1. Reduce the number of the stacked sheets.
To do this, suspend printing and remove the stacked sheets, and then resume printing.
 To suspend printing, press the Suspend [1] button on the finisher.
 To resume printing, press the Resume [1] button.