Ricoh Pro 8310 - If Using Paper of Paper Weights 1 to 4; If Using Paper of Paper Weights 5 to 7; Paper Skew; The Paper Buckle Amount Is Not Specified Correctly

3.Paper Delivery Problems
706
Paper Skew
Take the appropriate action according to the cause of the problem.
The side fences in the paper tray are too far apart.
 If the side fences are too far apart, the paper may be skewed. Adjust the side fences to match the
paper width.
 When you close the paper tray, the side fences may become misaligned due to the weight of the
paper. Close the paper tray slowly.
There is a scrap of paper or some other small fragment jammed in the paper feed path.
Remove the foreign object. (Cleaning the Paper Feed Path)
The paper buckle amount is not specified correctly.
Adjust the degree of paper arching at the registration gate.
If using paper of Paper Weights 1 to 4
1. On the Adjustment Settings for Skilled Operators menu, select Machine: Image Position, and
change the value in Adjust Registration Paper Buckle. (SP1-004-1 to 3: Reg. Buckle Adjust: Tray 1
to 3).
If using paper of Paper Weights 5 to 7
1. On the Adjustment Settings for Skilled Operators menu, select Machine: Image Position > Adjust
Registration Paper Buckle (Thick Paper). Change the value. (SP1-005-001 to 3: Reg. Buckle Adj.:
Thick 5 to Thick 7).
2. Increase (+) or decrease (-) the value for the paper tray in use, and then print the image.
 If the problem persists even though the setting has reached its maximum value, try decreasing
the setting.
 If the problem persists even though you have tried the complete range of settings from
minimum to maximum, perform the procedure in Leading Edge Shift Unit Manual Adjustment.
Leading Edge Shift Unit Manual Adjustment
1. Execute SP2109-003 Pattern #14, and then print a Trimming Area pattern on both sides of an A3
size sheet of paper.
2. Pull out the drawer.