To Next Page

To Previous Page

1.SC Codes

466

Major Cause

 Book rotation motor 2 (left) connector, loose, broken, defective

 Motor overloaded, obstructed, defective

 Book rotation HP sensor 2 (left) connector loose, broken, defective

Solution

 Reconnect the connector.

 Replace the book rotation motor 2 (left).

 Replace the book rotation HP sensor 2 (left).

 Replace the cutter control board.

 Replace the motor harness.

 Replace the sensor harness.

 Clear the signature jam.

After the repairs, cancel the low performance mode, and then turn the power off/on.

SC753-24

Error Name

Perfect Binder: Book rotation HP sensor (left) late error

Pattern

Error Condition

 The book rotation HP 2 (left) sensor did not go ON after the book was rotated 400 degrees.

 Before the book is rotated before cutting, the book rotation HP sensor 2 (left) did not go on, even

after the book had been rotated twice the prescribed distance.