Ricoh Pro 8310 - Tray 1 Does Not Close Completely.

5.Other Information
870
6. Make 20 copies of the same test pattern. Has the problem been resolved?
Yes
Finished.
No
Replace the developer. If replacing the developer does not resolve the problem, replace
the development unit.
Tray 1 Does Not Close Completely.
Cause
The tray lock lever needs adjustment because it does not reach the registration adjustment plate.
Solution
Follow this procedure to shift the registration adjustment plate to the front so the tray lock lever can
reach the registration adjustment plate.
1. Pull out Tray 1 completely so that the right and left tandem trays separate.
2. Remove the right tandem tray. ( x2)
3. On the registration adjustment plate, loosen screw [A], remove screw [B], and then and fasten it at