3.Paper Delivery Problems
724
Paper Edges Dirty 3 (Drum Speed)
Cause:
The paper feed speed of the decurl unit is too high.
To adjust the following settings, pre-register the type of paper in use as a custom paper. For
details see “3. Custom Paper Settings for Administrator” in the TCRU “Adjustment Item Menu
Guide”
Decreasing the paper feed speed of the decurl unit may result in creases, scratches, or paper
jams if thin paper is used.
Solution:
You can lessen the problem by decreasing the paper feed speed of the decurl unit.
1. On the machine operation panel: Adjustment Settings for Skilled Operators > Paper Feed/ Output >
Adjust Paper Curl > Check the decurl setting (Off, Weak, or Strong) in. (SP 1-906-001 to 012: De-
curler Setting Tray <number> :Paper Path Selection)
2. In Advanced Settings for the custom paper in use, adjust the paper feed speed of the decurl unit.
If the degree of decurling is set to "Off", reduce the value in Decurler Feed Speed Adj: Curl Adj
Off by 0.5%.
If the degree of decurling is set to "Weak", reduce the value in Decurler Feed Speed Adj: Curl
Adj Weak by 0.5%.
If the degree of decurling is set to "Strong", reduce the value in Decurler Feed Speed Adj: Curl
Adj Strg by 0.5%.
3. Print the image. Is the problem resolved?
Keep decreasing the value by 0.5% until the problem is resolved.
If the problem persists even though the setting has reached its minimum value, consult the
product specialist.
Images Scratched, Streaked, Creased
Cause:
To Next Page
Loading...
