Ricoh Pro 8310 - Blurred Images (Convex Lens Shaped)

2.Image Quality Problems
678
Cause:
Oblique (approximately 45°) thin lines or thin lines printed in faint colors with breaks.
Solution:
1. In the Adjustment Settings for Skilled Operators menu, select Machine: Image Quality > Adjust
Image Density > Image Density Adjustment: Manual Execute. (SP3-011-002: Manual ProCon :Ex
Density Adjustment)
2. Print the image. Is the problem resolved?
Yes
Finished.
No
Go to the next step.
3. Increase the value by 1 in Adjust Line Width. (SP3-623-061: LD Power :Set Line Width Adj.:K)
4. Select Adjust Image Density and execute Image Density Adjustment: Manual Execute. (SP3-011-
002: Manual ProCon :Ex Density Adjustment)
5. Print the image. Is the problem resolved?
Yes
Finished.
No
Repeat Steps 3 to 5. If the problem persists even though you have increased the value to
5, consult the product specialist.
Blurred Images (Convex Lens Shaped)
Lens-shaped blurred images appear at 314 mm (12.4 inch) intervals.
Cause:
If the machine is left unattended for a long period in an environment where temperature and humidity
are high, discharge on the drum surface absorbs moisture, and the drum cannot charge or discharge