Technical Bulletin PAGE: 39/44
Model: Aries-P1.5/C1.5 Date: 17-Feb-11 No.: RM077018
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
212. Check or clear obstacles around the motor drive
mechanism.
213. Check the harness connection.
214. Replace the booklet stapler motor - rear.
215. Replace the finisher main board.
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
Feed-Out Belt Motor Error (Finisher B830)
The stack feed-out belt HP sensor does not activate within the
specified time after the stack feed-out belt motor turns on.
The 1st detection failure causes a jam error, and the 2nd failure
causes this SC code.
If the motor is operating
Stack feed-out HP sensor harness loose, broken, defective
Stack feed-out HP sensor defective
If the motor is not operating:
Feed-out belt motor blocked by an obstruction
Feed-out belt motor harness loose, broken, defective
Feed-out belt motor defective
Booklet finisher main board defective
745 B
216. Check or clear obstacles around the motor drive
mechanism.
217. Check the harness connection.
218. Replace the stack feed-out belt HP sensor.
219. Replace the feed-out belt motor.
220. Replace the finisher main board.
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
Stack Plate Motor Error 1: Center Motor (B830)
The stack plate HP sensor (center) does not activate within 500
ms after the motor turns on.
The 1st detection failure causes a jam error, and the 2nd failure
causes this SC code.
746 B
If the motor is operating
Center stack plate HP sensor harness loose, broken, defective
Center stack plate HP sensor defective
If the motor is not operating:
Motor blocked by an obstruction
Motor harness loose, broken, defective
Motor defective
Finisher main board defective
To Next Page
Loading...
