Ricoh pro c901 - Removing Punch Waste; Finisher SR5000; Booklet Finisher SR5020

Removing Punch Waste
This section describes how to remove punch waste.
• While " Hole Punch Receptacle is full." is displayed, you cannot use the punch function.
• " Hole Punch Receptacle is full." is displayed until the punch waste box is reinstalled.
• If the message is still displayed, reinstall the punch waste box.
• While "Comb Binding Punch Receptacle is full." is displayed, you cannot use the punch function.
• "Comb Binding Punch Receptacle is full." is displayed until the receptacle is reinstalled.
• If the message is still displayed, reinstall the receptacle.
Finisher SR5000
This section describes how to remove punch waste from Finisher SR5000.
CAL131
Remove punch waste.
Reinstall the punch waste box.
Close the finisher front
cover.
Open the finisher front
cover.
Pull out the punch
waste box.
Booklet Finisher SR5020
This section describes how to remove punch waste from Booklet Finisher SR5020.
CAL132
Open the finisher
front cover.
Pull out the punch
waste box.
Remove punch waste.
Reinstall the punch waste box.
Close the finisher front
cover.
Removing Punch Waste
117
3