When You Have Problems Operating the
Machine
This section describes common problems and messages. If other messages appear, follow the instructions
displayed.
Problem Causes Solutions
The operation switch
indicator continues blinking
and does not turn off when
pressed.
This occurs in the following
cases:
• The machine is
communicating with
external equipment.
• The hard disk is active.
• The machine is cooling
down.
Check if the machine is communicating
with external equipment.
The display is off. The machine is in Energy
Saver mode.
Press the [Energy Saver] key to cancel
Energy Saver mode.
The display is off. The operation switch is turned
off.
Turn on the operation switch.
Nothing happens when the
operation switch is turned on.
The main power switch is
turned off.
Turn on the main power switch.
"Please wait." appears. This message appears when
you turn on the operation
switch.
Wait for a while. If the machine does not
get ready in two minutes, contact your
service representative.
"Please wait." appears. This message appears when
the machine is warming up.
• Wait for a while. If the machine
does not get ready in 10 minutes,
contact your service
representative.
• Wait until the message disappears.
Do not turn off the main power
switch while the message is
showing.
"Please wait." appears. This message appears when
you change the toner
cartridge.
Wait for a while. If the message does not
disappear in two minutes, contact your
service representative.
When You Have Problems Operating the Machine
19
To Next Page
Loading...
