4. Press the elevator switch on the multi bypass tray.
The green lamp of the elevator switch flashes when the tray is moving and remains lit when the tray
is still.
If you want to add new paper or remove jammed paper, first press the elevator switch to lower the
tray.
• If you load paper that cannot be automatically detected, specify its size using the display panel. For
details, see "Changing to a Size That Is Not Automatically Detected".
• p.69 "Changing to a Size That Is Not Automatically Detected"
Loading Paper into the Interposer
This section describes how to load paper into the interposer.
• Load paper in the interposer in the same orientation as paper in the paper tray.
• The staple or punching location will be on the left side of the paper, when you are facing the machine.
2. Adding Paper, Toner, Staples, Rings and Glue
50
To Next Page
Loading...
