Changing the Paper Size
This section explains how to change the paper size.
• When loading paper, take care not to trap or injure your fingers.
Procedures for changing the paper size differ depending on the tray.
• Be sure to select the paper size with Tray Paper Settings. If you do not, misfeeds might occur.
• Fan the paper before loading.
• Straighten curled or warped paper before loading.
• For details about paper sizes and types, see "Recommended Paper Sizes and Types", About This
Machine.
Changing the Paper Size in Tray 2
This section explains how to change the paper size in Tray 2.
• If a paper tray is pushed vigorously when putting it back into place, the position of the tray's side
fences may slip out of place.
• Do not stack paper over the limit mark.
• Check that the top of the paper is aligned with the right side.
• Slide the side fences until they are aligned with the paper size, and then re-lock the side fences. Make
sure there are no gaps between the paper and side fences.
1. Check that the paper tray is not in use, and then pull the tray carefully out until it stops.
2. Remove paper if loaded.
2. Adding Paper, Toner, Staples, Rings and Glue
60
To Next Page
Loading...
