1. Carefully pull out the paper tray until it stops.
2. Square the paper, and then load it print side down.
3. Carefully push the paper tray fully in.
• If you load paper that cannot be automatically detected, specify its size using the display panel. For
details, see "Changing to a Size That Is Not Automatically Detected".
• p.69 "Changing to a Size That Is Not Automatically Detected"
Loading Paper into the Large Capacity Tray
This section describes how to load paper in the LCT. The LCT is identified as Tray 3, Tray 4, and Tray 5.
• Various sizes of paper can be loaded in Tray 3 and Tray 4 by adjusting the positions of side fence
and end fence.
• If you want to change the paper size of Tray 5, contact your service representative.
• Check the paper edges are aligned at the left side.
2. Adding Paper, Toner, Staples, Rings and Glue
42
To Next Page
Loading...
