When Z-folded Paper Is Not Properly Aligned
This section describes what to do if Z-folded prints are not properly aligned.
Finisher SR5000
This section describes how to attach the Z-fold support tray for Finisher SR5000 to the finisher shift tray.
1. Press the [Suspend/Resume] key.
The key lights up.
2. Remove the prints.
3. Set the Z-fold support tray for the finisher shift tray.
Attach the Z-fold support tray by inserting the two protrusions on its underside into the holes on the
finisher shift tray.
4. Press the [Suspend/Resume] key.
The key turns off, and then printing restarts.
1. When the Machine Does Not Operate As Wanted
34
To Next Page
Loading...
