• The tray can hold up to 1,100 sheets in Tray 3 and 4, and 2,800 sheets in Tray 5. Do not stack paper
over the limit mark.
1. Carefully pull out the paper tray until it stops.
2. Load paper into the paper tray by pushing it against to the left side of the paper tray.
Load the paper print side up.
3. Carefully slide the paper tray fully in.
Loading Paper into the Wide Large Capacity Tray
This section describes how to load paper in the Wide LCT. The Wide LCT is identified as Tray 3, Tray 4,
Tray 5 and Tray 6.
• Up to two Wide LCTs can be installed.
• To install two Wide LCTs, the bridge unit is required.
• Various regular sizes of paper can be loaded in the Wide LCT by adjusting the positions of side fences
and end fence.
• Check that the paper edges are aligned with the left side.
• The tray can hold up to about 2,200 sheets of paper. Do not stack paper over the limit mark.
Loading Paper
43
To Next Page
Loading...
