2. Release the end fence.
3. Loosen the screws holding the side fences in position.
4. Load paper by aligning the paper with the left side of the paper tray.
Place paper with print side up.
Load a stack of paper about 5 - 10 mm (0.25 - 0.4 inches) high.
To load paper smaller than B5 JIS that has a vertical length of 139.7 to less than 257 mm (5.5 to
less than 10.12 inches), remove the paper supports. For details about how to remove the paper
supports, see "Loading small size paper into the Wide Large Capacity Tray".
Make sure the paper rest on top of the supporting plates on both sides.
1. Supporting plates
Changing the Paper Size
67
To Next Page
Loading...
