Configuring the Details of the Registered Information
94
7
-: Not Shown †: Confirmation Only ❍: Able to change
Device ID (RS-485) The ID for the device which is connected
by RS-485. “0” will be shown for the de-
vices on the network.
††
Method to assign IP
address
The method to assign IP address for the
devices on the network. Select from
“Specify” and “Auto-Obtain (DHCP).”
- ❍
SNMP community
name
The community name for SMTP corre-
spondent devices. Enter within 30 char-
acters.
† ❍
Device location The name of the place where the device is
located. Enter within 30 characters.
❍❍
Machine administra-
tor's E-mail address
The E-mail address for the device admin-
istrator. Notice E-mails such as “Updat-
ing device firmware” and “device
suspension” are sent to this address. En-
ter within 120 characters.
❍❍
Supply ordering per-
son's E-mail address
The E-mail address for the person re-
sponsible for keeping supplies. Enter
within 120 characters.
Depending on the area and service avail-
ability, the address might not be dis-
played.
❍❍
Service depot Your service representative. † †
Service depot contact The phone number of your service repre-
sentative.
††
Supply order from Your supply representative.
Depending on the area and service avail-
ability, the address might not be dis-
played.
††
Supply order phone
No.
The phone number of your supply repre-
sentative.
Depending on the area and service avail-
ability, the address might not be dis-
played.
††
Status This shows the status of the device.
• Power on
• Disconnected
• Power off
• Suspended
††
Items Descriptions Admin Registrant
To Next Page
Loading...