Ricoh Remote Communication Gate - Default Settings

Appendix
112
8
Default Settings
Note
❒ The default display language and time zone settings vary depending on
where the equipment is used.
Item Default Value Remarks
LAN type Wired
DHCP Disable
Subnet Mask 255.255.255.0 See the network setup screens
Ethernet speed Auto select
Proxy server Disable
Proxy port 8080
RC Gate E-mail address
(for sender)
rc_gate
Number of times to resend
E-mail
3 times
Resend E-mail interval time 15 seconds
SMTP server port 25
SMTP_AUTH Disable
POP before SMTP Disable
POP server port 110
Transmission speed Auto select If using wireless LAN
WEP (encryption) Disable If using wireless LAN
Line connection RC Gate and fax shared line Dial-up only
Pulse/Tone dialing line Tone dialing phone Dial-up only
Permit access by service Permit
Permit updating of Firmware
from Communication Server
Permit
IP address search range 0.0.0.0 to 0.0.0.0 If using [RC Gate Registration
Wizard]
SNMP Community Name public If using [RC Gate Registration
Wizard]
Display items 10 addresses If using [RC Gate Registration
Wizard]