Ricoh Remote Communication Gate - 2 Setup and Connection; Checking the Setup Environment

11
2. Setup and Connection
This chapter will describe how to setup and connect the equipment to the net-
work.
Checking the Setup Environment
R
WARNING:
R
CAUTION:
Place the equipment on a level and vibration free surface.
Place the equipment on a location that guarantees a space of 0.4inch (1cm) or
more from the front/back/left/right sides of the equipment.
Important
❒ Do not locate the equipment where it is exposed to:
• direct sunlight
• air conditioner, heater, or humidifier emission
• electronic/magnetic interference from radios, televisions, or other electri-
cal equipment
• Areas excessively cold, hot, or humid
• extreme heat, cold, or humidity
❒ Locate this equipment in a secure environment such as an enclosed office.
❒ This equipment supports manufacturer original I/O devices only.
❒ Connect this equipment and the image I/O devices to a responsibly adminis-
trated network that is protected by a firewall or a similar Internet security/vi-
rus protection facility.
❒ Choose reliable persons as the administrator and registrant. The administra-
tor is responsible for management and operation of the equipment; the regis-
trant is responsible for registering the equipment on the Communication
Server. Both must read the "Operating Instructions" and "Setup Guide" care-
fully.
• Confirm that the wall outlet is near the equipment and easily accessi-
ble so as to be unplugged quickly in an emergency.
• Keep the equipment away from humidity and dust. Otherwise a fire or an
electric shock might occur.
• Do not place the equipment on an unstable or tilted surface. If it topples
over, an injury might occur.