7. Press [OK].
The standby display appears.
To check the settings, press [Sender Name].
8. Specify the destination, and then press the [Start] key.
• You can confirm transmission results by using both the E-mail TX Results function, which sends the
results by e-mail, and the Communication Result Report printed by the machine. You can set
whether to use both of these together in User Parameter (switch 10, bit 6) in the Facsimile Features
menu. See “Parameter Settings”.
• You can use Communication Result Report, etc. to check usage status by specified users. If user
authentication is set, you can check usage by logged-in users. If User Code is set to sender, you
can count the number of uses by each user.
• To cancel the Sender Name, cancel the transmission. See “Canceling a Transmission”.
• p.151 "Canceling a Transmission"
• p.375 "Parameter Settings"
1. Transmission
142
To Next Page
Loading...
