• p.335 "General Settings"
• p.339 "Send Settings"
Closed Network
Transmission will only take place if the destination's Closed Network Code is the same as yours.
This function can stop you accidentally sending information to the wrong place.
• You must program a Closed Network Code beforehand, using Program Closed Network Code
under Facsimile Features. For details about the programming method, see “Initial Settings”.
• This function is not available with Internet Fax, e-mail transmission, and folder transmission.
1. Place the original, and then select the scan settings you require.
2. Press [TX Mode].
3. Select [Option Setting].
4. Press [Closed Network] to highlight it.
To cancel a Closed Network Transmission, press [Closed Network] again.
5. Press [OK] twice.
2. Other Transmission Features
182
To Next Page
Loading...
