Ricoh SP 5200S - SEP Code RX Result Report

SEP Code RX Result Report
This report is printed after each SEP Code Reception is completed and shows its result.
If E-mail TX Results is programmed in a Quick Operation Key, you can select whether a report e-mail is
sent after reception. For details about Quick Operation Key, see “General Settings”.
• You can turn this function on or off with the User Parameter (switch 03, bit 4) in the Facsimile
Features menu.
• If user authentication is set, you can select whether to display a destination with the User Parameter
(switch 04, bit 4) in the Facsimile Features menu.
• If user authentication is set, you can select whether to display a sender name with the User
Parameter (switch 04, bit 5) in the Facsimile Features menu.
• For details about Parameter Setting, see “Parameter Settings”.
• You can also check the result of a SEP Code Reception with the Journal.
• To view the report without text disruption, select a font of even character width in your e-mail
application's settings.
• p.335 "General Settings"
• p.375 "Parameter Settings"
1. Transmission
150
1