If the machine is set up to print a Communication Result Report, this report is not printed. Use it to keep a
record of failed transmissions so you can send them again.
• You can select whether the Communication Failure Report is automatically printed using the User
Parameter (switch 04, bit 1) in the Facsimile Features menu.
• This report is only printed if the Communication Result Report is turned off and a document could
not be successfully transmitted with Memory Transmission.
• You can select whether to include part of the original image on the report with the User Parameter
(switch 04, bit 7) in the Facsimile Features menu.
• If user authentication is set, you can select whether to display a destination with the User Parameter
(switch 04, bit 4) in the Facsimile Features menu.
• If user authentication is set, you can select whether to display a sender name with the User
Parameter (switch 04, bit 5) in the Facsimile Features menu.
• For details about Parameter Setting, see “Parameter Settings”.
• The Pg(s) column gives the total number of pages. The Page Not Sent column gives the number of
pages that could not be sent successfully.
• “Unprogrammed” indicates that the document could not be sent because the forwarding
destination is not programmed.
• “--” indicates that the e-mail or Internet Fax document was sent to the mail server programmed in
this machine. (However, this does not mean the e-mail was delivered.)
• p.375 "Parameter Settings"
Checking the Transmission Result (Transmission File Status)
247
To Next Page
Loading...
Need help?
General
