• p.78 "Specifying a Destination"
• p.427 "Maximum Values"
Sending originals using the exposure glass (Memory Transmission)
This section explains how to send originals by Memory Transmission using the exposure glass.
1. Make sure [Immed. TX] is not highlighted.
2. Place the first page of the original face down on the exposure glass.
3. Specify a destination.
4. Make the scan settings you require.
5. Press the [Start] key.
The machine starts scanning.
6. Place the next original on the exposure glass within 60 seconds when you send multiple
originals, and then repeat steps 4 and 5.
Repeat this step for each page.
7. Press the [ ] key.
The machine dials the destination and starts transmission.
Parallel Memory Transmission
This function dials while the original is being scanned.
Standard Memory Transmission stores the original in memory, and then dials the destination. However,
Parallel Memory Transmission allows you to confirm the connection status quickly. In addition, this
function scans the original faster than Immediate Transmission. This is useful when you are in a hurry and
need to use the original for another purpose.
• Standard Memory Transmission is used instead of Parallel Memory Transmission in the following
cases:
Transmission Modes
31
To Next Page
Loading...
Need help?
General
