Specify the G3 fax telephone number of the receiving machine.
Example: 0312345678
• To send to a G3 fax via a gateway connected to a public telephone line, you must specify it's the
receiver's machine telephone number. For example, if the receiver's fax number is
“0312345678”, specify “5678”. To send from an IP-Fax to G3 fax without using gatekeeper or
SIP server, you must register the gateway also.
• An alias telephone number is a number that is registered in the gatekeeper, and is available only in
the network to which the gatekeeper is connected.
• Pay attention to the number of telephone number digits set in the gateway/IP address conversion
table to avoid transmission error.
• SIP allows you to transmit and receive documents via an IPv6 network. This machine does not
support H.323 over IPv6.
• Although the machine can have multiple IP addresses in an IPv6 environment, only one address
can receive IP-Faxes.
• To send via IPv6, you must specify, for the receiver's IPv6 address and host name, the manually
configured address for the receiver's fax.
• For reception when not using SIP server in an IPv6 environment, you must specify this machine's
IPv6 address manually. This is not necessary if you are using SIP server.
• To send by IPv4 when using SIP server in a mixed IPv4/IPv6 environment, enter “v4:” at the
beginning of the IP-Fax destination. Likewise, to send by IPv6 when using SIP server in a mixed
IPv4/IPv6 environment, enter “v6:” at the beginning of the IP-Fax destination.
• “SIP call setup” is performed either by IPv4 or IPv6, depending on the configuration of your
environment.
Setting a port number
When using IP address and port number
To send to an IP-Fax destination, depending on the receiver's network configuration, you might
have to specify the IPv4 address and port number of the receiving machine. For example, if the
receiver's IPv4 address is “192.168.1.10” and the port number is “2100”, specify
“192.168.1.10:2100”. Similarly, if the receiver's IPv6 address is “fe80::0123:4567:89ab:cdef”
and the port number is “2200”, specify “[fe80::0123:4567:89ab:cdef]:2200”. Ask your network
administrator for details.
When using host name and port number
When you specify a host name, depending on the receiver's network configuration, you may need
to specify the host name and port number of the receiving machine. For example, if the receiver's
Specifying a Destination
85
To Next Page
Loading...
Need help?
General
