- 15 -
English
C324153200.fmIDM
Chapter 3
SAFETY INFORMATION 2
3.1. GENERAL NORMS
–During design and construction, the manufacturer has carefully considered the pos-
sible hazards and personal risks that may result from interaction with the machine.
In addition to observing the specific laws in force, the manufacturer has adopted all
"exemplary construction technique principles". The purpose of this information is to
advise the users to use extreme caution to avoid risks. However, discretion is inval-
uable. Safety is also in the hands of all the operators who interact with the machine.
–Carefully read the instructions published in the supplied manual and found directly
on the machine while strictly observing those concerning safety. Time dedicated to
reading will prevent unfortunate accidents; remembering what one was supposed to
do when the damage is already done is always too late.
–Pay attention to the meanings of the symbols on the applied stickers; their shape and
colour are significant to safety ends. Keep them legible and observe the indicated in-
formation.
–Never tamper, dodge, eliminate or by-pass the safety devices installed on the ma-
chine. Neglect to respect this requirement may cause serious risk to personal safety
and health.
–Personnel who are to perform any type of work on the machine during its lifetime
must possess specific technical skills, abilities and have acquired certified experi-
ence in the specific field. Neglect to observe these requirements may prove hazard-
ous to personal safety and health.
–The Manufacturer is not liable for any damage to the product inside the packs
during the wrapping and stabilising steps and during the following step.
3.2. HANDLING AND INSTALLATION NORMS
–Accomplish lifting and handling respecting the information supplied by the manufac-
turer directly indicated on the packing, on the machine and in the operating instruc-
tions.
Personnel who load, unload and transport the machine must possess skills and ac-
quired certified experience in the specific field and have command of the lifting vehi-
cles utilised.
–Loading and transportation must be carried out with equipment having adequate ca-
pacity by anchoring the machine in the points foreseen by the manufacturer. The per-
sonnel authorized in accomplishing these operations must have specific capacity
and experience as to safeguard proper safety and that of the persons involved.
Before loading the machine on transportation vehicles, make sure the machine and
its components are well centred and that the proportions do not exceed the foreseen
maximum dimensions. If necessary, arrange appropriate signals.
3.3. OPERATION AND USE NORMS
–In addition to being competent on machine use the operator must possess the skills
and acquired proficiency suited to the type of work to be accomplished.
Even after an opportune documentation, at first utilisation, if necessary, simulate
some tests to identify command and their main functions, in particular those concern-
ing the starting and stopping operations.
Evers GmbH Graf-Zeppelin-Str. 10 46149 Oberhausen Telefon +49 208 99475-0 Telefax +49 208 99475-31 evers@eversgmbh.de eversgmbh.de
To Next Page
Loading...
