Chapter 4
INFORMATION ON HANDLING AND INSTALLATION
- 24 -
English
C424153200.fmIDM
4.8. RECOMMENDATIONS FOR CONNECTIONS
Connections should be performed following the manufacturer’s indications in
the enclosed diagrams. Personnel authorised to perform this operation must
possess technical skills, abilities and have acquired certified experience in the
specific field and must perform connections professionally, taking into account
all the regulative and legislative requirements. When connections are complet-
ed, make sure these requisites were observed by performing a general inspec-
tion before making the unit operative.
4.9. ELECTRICAL CONNECTIONS
Standard models work with a mains voltage of:
–220/240V 1Ph-50/60 Hz
–220/240V 3Ph-50/60 Hz
–380/415V 3Ph+N-50/60 Hz
Proceed as follows for electrical
connections.
1 -Check that the mains voltage
(V) and frequency (Hz) corre-
spond to those of the machine.
(See the data plate and the wir-
ing diagram).
2- Turn the on/off switch to 0
(OFF).
3- Connect the power cord to the
outlet (A), as illustrated, ac-
cording to the network mains.
4- Switch on the power supply us-
ing the on/off switch.
5- Press the "Cycle Start" button.
The machine sets itself for the
operating cycle start.
6- When the "Start" button is
pressed, the table should rotate
in a clockwise direction.
220/240V 1PH+N
PE
LN
RNPE
220/240V 3PH
R
T
PE
S
PE R
N
380/415V 3PH+N
S
R
PE
N
T
RPEN
Evers GmbH Graf-Zeppelin-Str. 10 46149 Oberhausen Telefon +49 208 99475-0 Telefax +49 208 99475-31 evers@eversgmbh.de eversgmbh.de
To Next Page
Loading...
