Chapter 4
INFORMATION ON HANDLING AND INSTALLATION
- 21 -
English
C424153200.fmIDM
4.3. TRANSPORT AND HANDLING
–Transport, also according to the
destination, can be performed by
different vehicles.
The diagram represents the most
popular solutions.
–To avoid sudden movements,
during transportation anchor the
machine to the transportation
means in a correct manner.
For further transportation, recre-
ate the initial packaging condi-
tions for transport and handling.
4.4. INSTALLATION ENVIRONMENT CHARACTERISTICS
Careful consideration must be given to the place where the machine is to be installed,
in order to ensure that it may be easily operated, without creating any unnecessary
risks for personnel.
Therefore we suggest the following prerequisites:
–a room temperature of between +0°C and 40°C
–a suitably aired place so that when the machine is working, the degree of humidity is
not unpleasantly high/low from the point of view of the operator
–a sufficient lighting in order that a pleasant, relaxing working environment is created
for the operator
–a boundary area around the immediate working area, for safety reasons, as shown
in figure
–a flat surface, steady and without vibrations with adequate weight supporting capac-
ity, also in consideration of the palletised loads to be wrapped.
–The area must have an electric power distribution socket.
Use of this machine in explosive environments or when exposed to the ele-
ments is strictly forbidden.
Evers GmbH Graf-Zeppelin-Str. 10 46149 Oberhausen Telefon +49 208 99475-0 Telefax +49 208 99475-31 evers@eversgmbh.de eversgmbh.de
To Next Page
Loading...
